John Che
07-27-2011, 10:53 AM
What you will need:
- Hand Controller (THC or 6-AXIS LENS CONTROLLER)
- MicroSD Card **formatted at FAT32**
- Power source for Hand Controller (Battery or from the Beam Splitter Rig)
- Current firmware from Technica 3D's firmware page: http://www.technica3d.com/support/firmware.php
Process:
- Format the microSD card (FAT32 only!)
- Copy the firmware onto the microSD card, DO NOT COPY INTO A FOLDER. Firmware must be in root directory.
- Power off the THC/6-AXIS
- Place microSD card into the microSD card holder located in the BATTERY BAY
- Using either a battery or power from the Beam Splitter Rig, power on the hand controller. (the "BATTERY" LED will flash rapidly for about 15 seconds. When the flashing stops, installation is complete.
- Power off and remove card
John Che
4501 W. Jefferson Blvd
p: (323)-641-7327 x224
e: john@elementtechnica.com
- Hand Controller (THC or 6-AXIS LENS CONTROLLER)
- MicroSD Card **formatted at FAT32**
- Power source for Hand Controller (Battery or from the Beam Splitter Rig)
- Current firmware from Technica 3D's firmware page: http://www.technica3d.com/support/firmware.php
Process:
- Format the microSD card (FAT32 only!)
- Copy the firmware onto the microSD card, DO NOT COPY INTO A FOLDER. Firmware must be in root directory.
- Power off the THC/6-AXIS
- Place microSD card into the microSD card holder located in the BATTERY BAY
- Using either a battery or power from the Beam Splitter Rig, power on the hand controller. (the "BATTERY" LED will flash rapidly for about 15 seconds. When the flashing stops, installation is complete.
- Power off and remove card
John Che
4501 W. Jefferson Blvd
p: (323)-641-7327 x224
e: john@elementtechnica.com