3D Basics
Section 2 - INTRODUCTION TO "QUASAR"
The Hand Controller
- The Quasar hand controller is precision machined for both balance and ergonomics
- It weighs xx lbs (with Battery) and incorporates three independent controls over two channels
- The hand controller communicates either wirelessly through a Blue Tooth connection with a range of +/- 300 FT or wired through a dedicated four pin cable. It can easily be switched between communication modes and operates the same in each
- I/O is controlled either with a scalable slide control or a markable dial configuration. The travel range can be broadened or limited from shot to shot with a simple and quick three step process
- Convergence is controlled by a large side mounted dial with a wide marking ring which makes scaling and marking very easy. Again the travel range can be broadened or limited very simply and quickly by the same process as I/O control
- The whole unit is powered externally by a standard Sony NP-FM50, 7.2 volt battery which has a quick charge cycle and are readily available at any photography or electronics store.
<<< Previous Page: Mirror Box || Next Page: Other Elements that make up the Rig >>>